Go to the fix. 29-09-2020 1:45 PM. @hugonebula I'm using a Zyxel 3925-B10C (the replacement for the JL 8924) on PlusNet and it works fine, so I don't see why your 8924 shouldn't. Looking at your config, I'd suggest changing to IPV4 only as PN don't support IPV6 yet. Also set the IDLE Timeout to 0 (disable).
1) Connect your router 2) Login to your router 3) Use Quick Start Wizard Setup 4) WAN Connection is Down 5) Firmware upgrade . 1) Connect your router. a) to your internet through the "DSL" port on your router. b) your PC to the LAN port of the router . 2) Login to your router
Navigate to Network > Interface > LAG and add a new interface under “ Configuration ”. Tick the “ Enable Interface ” checkbox, set the “ Interface Type ” to “ Internal ”, type in a name and choose the appropriate security “ Zone ”. Scroll down to “ LAG Configuration ”, change the “ Mode ” to “ balance-alb ”.
Next run a second Ethernet cable from one of the LAN ports (Yellow Ports) on the NBG router to your computer. Plug the power cable to the NBG router to turn it ON. Allow 30 seconds for the router to boot-up. Accessing the Web Configurator. Connect your modem, router and computer based on the diagram above. Launch your web browser.
Normally, your router will assign an IP address to the NAS. In this tutorial, we assume that the NAS gets an IP assigned. If not, you need the NAS Starter Utility, which you can download here.
18 days ago. Updated. In this article we show you how to set up a WiFi on your LTE3302. 1. Either connect your computer directly to one of the LAN ports of the LTE3302 or connect to the pre-configured WiFi (SSID and PSK are stated on the back of the device) 2. Login to the routers default IP 192.168.1.1 using the default credentials admin/1234. 3.
7iGn. 503 12 57 647 814 166 206 363
can t connect to zyxel router
